DISQUE FREIN MOTO EBC MD3111C

EBC Contour brake disc

The aim of the development is to improve the braking performance compared to the original brake disc. EBC uses heat-treated carbon steel for the MX Contour brake discs. This steel is much more resistant to rust than cast steel.

In addition, the entire surface is protected with a 3-micron thick zinc coating, which is worn away in the area of the brake pad contact zone already during braking.

Only in this area can light flash rust form with longer service life.

The brake discs are drilled in a birdcage design in order to get by with as few holes as possible while at the same time optimising the cleaning of the brake disc from rainwater and brake dust. The fewer the holes, the better the wet braking performance and the lower the wear.

- Cutting-edge Contour design

- Rigid brake disc, super light, completely new profile.

- Made from heat treated carbon steel.

- Braking surface drilled with optimized hole pattern.

- Radially ground.

- Zinc plated to protect against corrosion.

- Independent design.

- Thickness of brake disc may vary from original part.

MADE IN UK