PIAGGIO 226292 Motorcycle throttle cable

Cable Throttle for Vespa all models, models, with sleeve and barrel nipple, l (cable)=2000mm, Ø 1,25mm/4,5mm, l (sleeve)=1800mm Cables are among the most important spare parts. You should carry a spare set on your scooter and you should also keep a spare set in your garage at home. Snapped cables are an annoyance on every excursion. Cables which are hard to pull take their toll on the nerves and tendons. Frayed cables have to be replaced. For this reason, whether it is a restoration or annual service, replacing the cables on a regular basis is recommended. We only stock high quality cables which we fit to our own scooters. They are available as individual cables, cables with sleeve and optionally also with PTFE sleeve. They differ in terms of their length and diameter and the appearance and colour of the sleeve. Certain throttle, choke and brake cables differ depending on the specific model. Cables with PTFE sleeves are perfect for tight installation radii and are very easy to operate. The interior section of the sleeve has a special lining which has a clearly superior effect on the running and the lifespan of the cable. These cables do not require lubricating either. SIP-TIP: Order screw nipple and new adjusting screws at the same time! Everything apart from PTFE has to be lubricated with oil or grease! Throttle cable:With barrel nipple: To be attached to the throttle pulley, screw nipple throttle PART No 94230000 or 942631000 and/or solder nipple PART No 94232000 are required for attachment to the carburettor. With solder nipple: To be attached to the gas piston, screw nipple throttle PART No 94230000 or 942631000 and/or solder nipple PART No 94234000 are required for attachment to the throttle pulley.###226292(PIAGGIO)